Configuring Cisco Switches for Link Aggregation Load Sharing Mode
These are sample configuration commands for Cisco switches.
For 802.3ad (LACP)
Switch# conf t Switch(config)# port-channel load-balance src-dst-ip Switch(config)# interface FastEthernet <all the participating ports> Switch(config-if)# channel-group 1 mode active Switch(config-if)# channel-protocol lacp Switch(config-if)# exit Switch(config)# interface port-channel 1 Switch(config-if)# switchport access vlan <desired vlan number> Switch(config-if)# end Switch# write |
For XOR
Switch# conf t Switch(config)# port-channel load-balance src-dst-ip Switch(config)# interface FastEthernet <all the participating ports> Switch(config-if)# channel-group 1 mode on Switch(config-if)# exit Switch (config)# interface port-channel 1 Switch(config-if)# switchport access vlan <desired vlan number> Switch(config-if)# end Switch# write |