fwm verify

Important - This command is obsolete for R80 and higher. Use the mgmt_cli command to verify a policy on a managed Security GatewayClosed Dedicated Check Point server that runs Check Point software to inspect traffic and enforce Security Policies for connected network resources..

Description

Verifies the specified policy package without installing it.

Note

On a Multi-Domain ServerClosed Dedicated Check Point server that runs Check Point software to host virtual Security Management Servers called Domain Management Servers. Synonym: Multi-Domain Security Management Server. Acronym: MDS., you must run this command in the context of the applicable Domain Management ServerClosed Check Point Single-Domain Security Management Server or a Multi-Domain Security Management Server.:

mdsenv <IP Address or Name of Domain Management Server>

Syntax

fwm [-d] verify <Policy Name>

Parameters

Parameter

Description

-d

Runs the command in debug mode.

Use only if you troubleshoot the command itself.

Best Practice - If you use this parameter, then redirect the output to a file, or use the script command to save the entire CLI session.

For complete debug instructions, see the description of the fwm process in sk97638.

<Policy Name>

Specifies the name of the policy package as configured in SmartConsoleClosed Check Point GUI application used to manage a Check Point environment - configure Security Policies, configure devices, monitor products and events, install updates, and so on..

Example

[Expert@MGMT:0]# fwm verify Standard
 Verifier messages:
Error: Rule 1 Hides rule 2 for Services & Applications: any .
[Expert@MGMT:0]#