cp_conf auto

Description

Shows and controls which of Check Point products start automatically during boot.

Note - This command corresponds to the option Automatic start of Check Point Products in the cpconfig menu.

Syntax

cp_conf auto

-h

{enable | disable} <Product1> <Product2> ...

get all

Parameters

Parameter	Description
`-h`	Shows the applicable built-in usage.
`{enable \| disable} <Product1> <Product2> ...`	Controls whether the installed Check Point products start automatically during boot. This command is for Check Point use only.
`get all`	Shows which of these Check Point products start automatically during boot: Check Point Security Gateway Dedicated Check Point server that runs Check Point software to inspect traffic and enforce Security Policies for connected network resources. QoS Check Point Software Blade on a Security Gateway that provides policy-based traffic bandwidth management to prioritize business-critical traffic and guarantee bandwidth and control latency. (former FloodGate-1) SmartEvent Suite

Parameter

Description

-h

Shows the applicable built-in usage.

{enable | disable} <Product1> <Product2> ...

Controls whether the installed Check Point products start automatically during boot.

This command is for Check Point use only.

get all

Shows which of these Check Point products start automatically during boot:

Check Point Security Gateway Dedicated Check Point server that runs Check Point software to inspect traffic and enforce Security Policies for connected network resources.
QoS Check Point Software Blade on a Security Gateway that provides policy-based traffic bandwidth management to prioritize business-critical traffic and guarantee bandwidth and control latency. (former FloodGate-1)
SmartEvent Suite

Example from a Security Management Server

[Expert@MGMT:0]# cp_conf auto get all
Check Point Security Gateway is not installed
 
QoS is not installed
 
The SmartEvent Suite will start automatically at boot time.
 
[Expert@MGMT:0]#