Adding a Network Interface

When you add a network interface card to a Security GatewayClosed Dedicated Check Point server that runs Check Point software to inspect traffic and enforce Security Policies for connected network resources., the Multi-QueueClosed An acceleration feature on Security Gateway that configures more than one traffic queue for each network interface. Multi-Queue assigns more than one receive packet queue (RX Queue) and more than one transmit packet queue (TX Queue) to an interface. Multi-Queue is applicable only if SecureXL is enabled (this is the default). Acronym: MQ. configuration can change due to the way the operating system indexes the interfaces.

If you added a network interface card to a Security Gateway, make sure to either configure the Multi-Queue again, or apply the existing Multi-Queue configuration:

mq_mng --reconf