Configuring Router Discovery in Gaia Clish
|
Important - In a Cluster |
-
To see the available "
set
" commands for Router Discovery, enter in Gaia ClishThe name of the default command line shell in Check Point Gaia operating system. This is a restricted shell (role-based administration controls the number of commands available in the shell).:
set rdisc[Esc][Esc]
-
To see the available "
show
" commands for Router Discovery, enter in GaiaCheck Point security operating system that combines the strengths of both SecurePlatform and IPSO operating systems. Clish:
show rdisc[Esc][Esc]

|

Parameter |
Description |
||
---|---|---|---|
|
Disables ( |
||
|
Optional. Configures how long an advertised address remains valid in the absence of an update message. This value must not be less than the configured The configured value is placed in the "Lifetime" field of Route Advertisement messages sent on this interface. Range: 5-9000 seconds Default: 3 x (Value of |
||
|
Specifies whether this interface IP address should be advertised in ICMP Router Discovery advertisement messages. The specified IP address must be a valid interface IP address for the interface.
|
||
|
Disables ( |
||
|
Optional. Configures the preference of the address as a default router IP address, relative to other router IP addresses on the same subnet. Higher numeric values indicate greater preference. Range: 0-2147483647, or ineligible (indicates that the IP address should not be used as a default IP address) Default: 0 For more information, see the PreferenceLevel in RFC 1256. |
||
|
Optional. Configures the maximum time between sending ICMP Router Discovery advertisements on the interface. This value cannot be less than the configured Range: 4-1800 seconds Default: 600 seconds |
||
|
Optional. Configures the minimum time between sending ICMP Router Discovery advertisements on the interface. This value cannot be larger than the configured Range: 3-1799 seconds Default: 0.75 x (Value of |