Configuring IPv6 OSPFv3 Router ID

The Router ID uniquely identifies the router in the autonomous system.

By default, GaiaClosed Check Point security operating system that combines the strengths of both SecurePlatform and IPSO operating systems. Operating System selects the highest IPv4 address from all configured interfaces.

The Router ID is used by the OSPFv3 and BGP protocols.

>

Best Practice - Configure the Router ID explicitly, rather than relying on the default setting. Setting the Router ID prevents the ID from changing if the default interface used for the router ID goes down. Use an address on a loopback interface that is not the loopback address 127.0.0.1 (configure an additional Loopback interface and assign an IP address to it from the 128.0.0.x / 24 subnet - see the R81 Gaia Administration Guide).

Important:

You can configure the IPv6 OSPFv3 Router ID in Gaia PortalClosed Web interface for the Check Point Gaia operating system. or Gaia ClishClosed The name of the default command line shell in Check Point Gaia operating system. This is a restricted shell (role-based administration controls the number of commands available in the shell)..

To configure the Global Router ID

  1. From the left navigation tree, click Advanced Routing > IPv6 OSPF.

  2. In the Instances section, select the Default instance.

  3. In the Router ID section, enter the IPv4 address.

  4. Click Apply Router ID.

To configure the Router ID for an OSPFv3 Instance

  1. From the left navigation tree, click Advanced Routing > IPv6 OSPF.

  2. In the Instances section, select the instance (other than Default).

  3. In the Router ID section, enter the IPv4 address.

  4. Click Apply Router ID.

Syntax to configure the Global Router ID

set router-id {<IPv4 Address> | default}

Syntax to configure the Router ID for an OSPFv3 Instance

set ipv6 ospf3 instance {<1-65535> | default} router-id {<IPv4 Address> | default}

Parameters

Parameter

Description

instance {<1-65535> | default}

Specifies an OSPFv3 Instance ID to configure.

If you configure the Router ID for an OSPFv3 Instance, this Router ID overrides the Global Router ID configured on the system.

<IP Address>

Specifies a specific IPv4 address in dotted-quad ([1-255].[1-255].[1-255].[1-255]) format.

default

Selects the highest interface address when OSPFv3 is enabled.

Syntax to view the Global Router ID

show router-id

Syntax to view the Router ID of an OSPFv3 Instance

show ipv6 ospf3 instance {<1-65535> | default} router-id

Parameters