Configuring IPv6 Neighbor Entries

Description

You can add and delete entries in the Gaia Check Point security operating system that combines the strengths of both SecurePlatform and IPSO operating systems. IPv6 Neighbor table.

Note - You can add or delete Neighbor entries only from the Gaia Clish The name of the default command line shell in Check Point Gaia operating system. This is a restricted shell (role-based administration controls the number of commands available in the shell)..

Important - First, you must enable the IPv6 Support and reboot (see System Configuration).

Syntax

• To add an IPv6 neighbor entry:

  add neighbor-entry ipv6-address <IPv6 Address of Neighbor> macaddress <MAC Address of Neighbor> interface <Name of Local Interface>

• To show an IPv6 neighbor entry:

  show neighbor<SPACE><TAB>

  show neighbor TABLE

• To delete an IPv6 neighbor entry:

  delete neighbor-entry ipv6-address <IPv6 Address of Neighbor> interface <Name of Local Interface>

Important - After you add, configure, or delete features, run the "save config" command to save the settings permanently.

Parameters

Parameter	Description
<IPv6 Address of Neighbor>	Specifies the IPv6 address of a new static Neighbor Discovery entry
<MAC Address of Neighbor>	Specifies the MAC address for respective IPv6 address
<Name of Local Interface>	Name of the local interface that connects to the Neighbor