Host Access

You can configure hosts or networks that are allowed to connect to the Gaia Portal Web interface for the Check Point Gaia operating system. or Gaia Clish The name of the default command line shell in Check Point Gaia operating system. This is a restricted shell (role-based administration controls the number of commands available in the shell). on the Gaia Check Point security operating system that combines the strengths of both SecurePlatform and IPSO operating systems. device.

Configuring Allowed Gaia Clients in Gaia Portal

Step	Instructions
1	In the navigation tree, click System Management > Host Access.
2	Click Add. The Add a New Allowed Client window opens.
3	Select one of these options: Any host - All remote hosts can access the Gaia Portal, or Gaia Clish. Host - Enter the IPv4 address of one host. Network - Enter the IPv4 address of a network and subnet mask.
4	Click OK.

Configuring Allowed Gaia Clients in Gaia Clish

Syntax

To add an allowed client:

add allowed-client

      host

            any-host

            ipv4-address <Host IPv4 Address>

      network ipv4-address <Network IPv4 Address> mask-length <1-31>

To show the configured allowed clients:

show allowed-client all

To delete an allowed client:

delete allowed-client

      host

            any-host

            host ipv4-address <Host IPv4 Address>

      network ipv4-address <Network IPv4 Address>

Important - After you add, configure, or delete features, run the "save config" command to save the settings permanently.

Parameters

Parameter	Description
`<Host IPv4 Address>`	The IPv4 address of the allowed host in dotted decimal format (X.X.X.X)
`<Network IPv4 Address>`	The IPv4 address of the allowed network in dotted decimal format (X.X.X.X)

Example

gaia> add allowed-client host any-host
gaia> show allowed-client all
Type                  Address                                   Mask Length
Host                  Any
gaia>