Configuring ARP in Gaia Portal

Step

Instructions

1

In the navigation tree, click Network Management > ARP.

2

In the upper right corner, click the Monitoring tab.

Step

Instructions

1

In the navigation tree, click Network Management > ARP.

2

In the upper right corner, click the Configuration tab.

Step

Instructions

1

In the navigation tree, click Network Management > ARP.

2

In the upper right corner, click the Configuration tab.

3

In the ARP Table Settings section:

  1. Enter the Maximum Entries.

    This is the maximal number of entries in the ARP cache.

    Range: 1024 - 131072 entries

    Default: 4096 entries

    Note - Make sure to configure a value large enough to accommodate at least 100 dynamic entries, in addition to the maximum number of static entries.

  2. Enter the Validity Timeout.

    This is the time, in seconds, resolved dynamic ARP entries are checked for validity.

    If the entry is not referred to and is not used by traffic before the time elapses, it is marked as STALE.

    Otherwise, a request is sent to verify the MAC address.

    Range: 60 - 86400 seconds (24 hours)

    Default: 60 seconds

Step

Instructions

1

In the navigation tree, click Network Management > ARP.

2

In the upper right corner, click the Configuration tab.

3

In the Static ARP Entries section, click Add.

4

Enter the IP Address of the static ARP entry and the MAC Address used when forwarding packets to the IP address.

5

Click OK.

Step

Instructions

1

In the navigation tree, click Network Management > ARP.

2

In the upper right corner, click the Configuration tab.

3

In the Static ARP Entries section, select a Static ARP entry.

4

Click Remove.

Step

Instructions

1

In the navigation tree, click Network Management > ARP.

2

In the upper right corner, click the Monitoring tab.

3

Click Flush All.