Setting Rules to Prevent

To set a rule to Prevent:

1. In SmartConsole Check Point GUI application used to manage a Check Point environment - configure Security Policies, configure devices, monitor products and events, install updates, and so on., select Security Policies > Shared Policies > DLP and click Open DLP Policy in SmartDashboard.

   SmartDashboard Legacy Check Point GUI client used to create and manage the security settings in versions R77.30 and lower. In versions R80.X and higher is still used to configure specific legacy settings. opens and shows the DLP tab.

2. From the navigation tree, click Policy.

3. In the Action column of the rule Set of traffic parameters and other conditions in a Rule Base (Security Policy) that cause specified actions to be taken for a communication session. to change, right-click and select Prevent.

4. Click Save and then close SmartDashboard.

5. In SmartConsole, install policy.