cphastart

Description

Starts the cluster configuration on a Cluster Member after it was stopped with the cphastop command.

Best Practice - To start a Cluster Member, use the cpstart command.

Note - This command does not initiate a Full Synchronization on the Cluster Member.

Syntax

cphastart

      [-h]

      [-d]

Parameters

Parameter

Description

-h

Shows the applicable built-in usage.

-d

Runs the command in debug mode.

Use only if you troubleshoot the command itself.

Best Practice - If you use this parameter, then redirect the output to a file, or use the script command to save the entire CLI session.

Refer to:

  • These lines in the output file:

    prepare_command_args: -D ... start

    /opt/CPsuite-R81/fw1/bin/cphaconf clear-secured

    /opt/CPsuite-R81/fw1/bin/cphaconf -D ...(truncated here for brevity)... start

  • The $FWDIR/log/cphastart.elg log file.