fwaccel synatk monitor

Description

The "fwaccel synatk monitor" and "fwaccel6 synatk monitor" commands show the Accelerated SYN Defender status.

Important - To enable the Accelerated SYN Defender in Monitor (Detect only) mode on all interfaces, you must run the fwaccel synatk -m command.

Syntax for IPv4

fwaccel synatk monitor

      [-p]

      [-p] -a

      [-p] -s

      [-p] -v

Syntax for IPv6

fwaccel6 synatk monitor

      [-p]

      [-p] -a

      [-p] -s

      [-p] -v

Parameters

Important - You can specify only one of these parameters: -a, -s, or -v.

Parameter

Description

-p

Shows the Accelerated SYN Defender status for each SecureXLClosed Check Point product on a Security Gateway that accelerates IPv4 and IPv6 traffic that passes through a Security Gateway. instance ("PPAK ID: 0" is the Host Security Appliance).

[-p] -a

Shows the Accelerated SYN Defender statistics for all interfaces (for each SecureXL instance).

[-p] -s

Shows the attack state in short form (for each SecureXL instance).

[-p] -v

Shows the attack state in verbose form (for each SecureXL instance).

Examples