Mail Notification

Introduction

Mail notifications (also known as Mail Relay) allow you to send email from the Security GatewayClosed Dedicated Check Point server that runs Check Point software to inspect traffic and enforce Security Policies for connected network resources..

You can send email interactively or from a script. The email is relayed to a mail hub that sends the email to the final recipient.

Mail notifications are used as an alerting mechanism when a Firewall ruleClosed Set of traffic parameters and other conditions in a Rule Base (Security Policy) that cause specified actions to be taken for a communication session. is triggered. It is also used to email the results of cron jobs to the system administrator.

GaiaClosed Check Point security operating system that combines the strengths of both SecurePlatform and IPSO operating systems. supports these mail notification features:

  • Presence of a mail client or Mail User Agent (MUA) that can be used interactively or from a script.

  • Presence of a Sendmail-like replacement that relays mail to a mail hub by using SMTP.

  • Ability to specify the default recipient on the mail hub.

Gaia does not support these mail notification features:

  • Incoming e-mail.

  • Mail transfer protocols other than outbound SMTP.

  • Telnet to port 25.

  • E-mail accounts other than admin or monitor.

Configuring Mail Notification in Gaia Portal

Important - On Scalable Platforms (Maestro and Chassis), you must connect to the Gaia PortalClosed Web interface for the Check Point Gaia operating system. of the applicable Security Group.

Step

Instructions

1

In the navigation tree, click System Management > Mail Notification.

2

In the Mail Server field, enter the IPv4 Address or Hostname of the mail server.

For example: mail.example.com

3

In the User Name field, enter the user name.

For example: user@mail.example.com

4

Click Apply.

Configuring Mail Notification in Gaia Clish

Important - On Scalable Platforms (Maestro and Chassis), you must run the applicable commands in Gaia gClish of the applicable Security Group.

Description

Use this group of commands to configure mail notifications.

Syntax

  • To configure the mail server that receives the mail notifications:

    set mail-notification server <IPv4 Address or Hostname>

  • To configure the user on the mail server that receives the mail notifications:

    set mail-notification username <User Name>

  • To show the configured mail server and user:

    show mail-notification
          server
          username

Important - After you add, configure, or delete features, run the "save config" command to save the settings permanently.

Parameters

Parameter

Description

server <IPv4 Address or Hostname>

The IPv4 address or Hostname of the mail server, to which Gaia sends mail notifications.

Example: mail.company.com

username <User Name>

The username on the mail server that receives the admin or monitor mail notifications.

Example: johndoe

Example

gaia> set mail-notification server mail.company.com

gaia> set mail-notification username johndoe

gaia> show mail-notification server

Mail notification server: mail.company.com

gaia> show mail-notification username

Mail notification user: johndoe