Configuring Hyper-Threading
Hyper-Threading mechanism runs more than one process at the same time on a CPU core.
A physical CPU that supports Hyper-Threading, adds one or more logical CPUs, which the operating system sees as independent CPUs.
To enable Hyper-Threading:
|
Step |
Instructions |
|
|---|---|---|
|
1 |
Connect to the command line on the chassis. |
|
|
2 |
Log in to Gaia Clish or the Expert mode. |
|
|
3 |
Start the Check Point Configuration Tool:
|
|
|
4 |
Select Configure HyperThreading. |
|
|
5 |
Follow the on-screen instructions. |
|
|
Note - Hyper-Threading is enabled by default on the SGM260. |
|
|
Important - You must reboot all SGMs after all changes in the Hyper-Threading configuration. |
