Inspection Settings - General

What can I do here?

Use this window to view Threat Prevention protections and their settings.

For configuring individual inspections, see: Inspection Settings

Getting Here - Manage & Settings > Blades > General > Inspection Settings > General

 

Inspection Settings

You can configure inspection settings for the Firewall:

  • Deep packet inspection settings

  • Protocol parsing inspection settings

  • VoIP packet inspection settings

The Security Management ServerClosed Dedicated Check Point server that runs Check Point software to manage the objects and policies in a Check Point environment within a single management Domain. Synonym: Single-Domain Security Management Server. comes with two preconfigured inspection profiles for the Firewall:

  • Default Inspection

  • Recommended Inspection

When you configure a Security Gateway, the Default Inspection profile is enabled for it. You can also assign the Recommended Inspection profile to the Security Gateway, or to create a custom profile and assign it to the Security Gateway.

To activate the Inspection Settings, install the Access Control Policy.

Note - In a pre-R80 SmartConsoleClosed Check Point GUI application used to manage a Check Point environment - configure Security Policies, configure devices, monitor products and events, install updates, and so on., Inspection Settings are configured as IPSClosed Software Blade on a Check Point Firewall that inspects and analyzes packets and data for numerous types of risks (Intrusion Prevention System). Protections.

Inspection Settings Table

Column

Description

Protection

Name of the protection

Performance Impact

How much this protection and its resources affect gateway or server performance

Profile

Displays profiles created on the Profiles page