NAT

What can I do here?

Use this window to configure Network Address Translation.

Getting Here - Object Explorer > New > Network > NAT page Or: Object Explorer > New > Host > NAT page

Translating IP Addresses

NAT (Network Address Translation) is a feature of the Firewall Software Blade and replaces IPv4 and IPv6 addresses to add more security. You can enable NAT for all SmartConsole objects to help manage network traffic. NAT protects the identity of a network and does not show internal IP addresses to the Internet. You can also use NAT to supply more IPv4 addresses for the network.

The Firewall can change both the source and destination IP addresses in a packet. For example, when an internal computer sends a packet to an external computer, the Firewall translates the source IP address to a new one. The packet comes back from the external computer, the Firewall translates the new IP address back to the original IP address. The packet from the external computer goes to the correct internal computer.

SmartConsole gives you the flexibility to make necessary configurations for your network:

• Easily enable the Firewall to translate all traffic that goes to the internal network.
• SmartConsole can automatically create Static and Hide NAT rules that translate the applicable traffic.
• You can manually create NAT rules for different configurations and deployments.

How Security Gateways Translate Traffic

A Security Gateway can use these procedures to translate IP addresses in your network:

• Static NAT - Each internal IP address is translated to a different public IP address. The Firewall can allow external traffic to access internal resources.
• Hide NAT - The Firewall uses port numbers to translate all specified internal IP addresses to a single public IP address and hides the internal IP structure. Connections can only start from internal computers, external computers CANNOT access internal servers. The Firewall can translate up to 50,000 connections at the same time from external computers and servers.
• Hide NAT with Port Translation - Use one IP address and let external users access multiple application servers in a hidden network. The Firewall uses the requested service (or destination port) to send the traffic to the correct server. A typical configuration can use these ports: FTP server (port 21), SMTP server (port 25) and an HTTP server (port 80). It is necessary to create manual NAT rules to use Port Translation.

Using Hide NAT

For each SmartConsole object, you can configure the IP address that is used to translate addresses for Hide NAT mode:

• Use the IP address of the external Security Gateway interface
• Enter an IP address for the object

Hide NAT uses dynamically assigned port numbers to identify the original IP addresses. There are two pools of port numbers: 600 to 1023, and 10,000 to 60,000. Port numbers are usually assigned from the second pool. The first pool is used for these services:

• rlogin (destination port 512)
• rshell (destination port 513)
• rexec (destination port 514)

If the connection uses one of these services, and the source port number is below 1024, then a port number is assigned from the first pool.

You cannot use Hide NAT for these configurations:

• Traffic that uses protocols where the port number cannot be changed
• An external server that uses IP addresses to identify different computers and clients