Configuring Browser-Based Authentication in SmartConsole

In the Identity Sources section of the Identity Awareness page, select Browser-Based Authentication to send unidentified users to the Captive Portal.

If you configure Transparent Kerberos Authentication (see Transparent Kerberos Authentication Configuration), the browser tries to identify AD users before sending them to the Captive Portal.

If you already configured the portal in the Identity Awareness Wizard or SmartConsole, its URL shows below Browser-Based Authentication.

To configure the Browser-Based Authentication settings:

  1. Select Browser-Based Authentication and click Settings.

  2. From the Portal Settings window, configure:

    Note - When you enable Browser-Based Authentication on an IPSO Security Gateway that is on an IP Series appliance, make sure to set the Voyager management application port to a port other than 443 or 80.