Configuring the Cluster Control Protocol (CCP) Settings

Important - In a Cluster Two or more Security Gateways that work together in a redundant configuration - High Availability, or Load Sharing., you must configure all the Cluster Members in the same way.

Description

Cluster Members configure the Cluster Control Protocol Proprietary Check Point protocol that runs between Cluster Members on UDP port 8116, and has the following roles: (1) State Synchronization (Delta Sync), (2) Health checks (state of Cluster Members and of cluster interfaces): Health-status Reports, Cluster-member Probing, State-change Commands, Querying for cluster membership. Note: CCP is located between the Check Point Firewall kernel and the network interface (therefore, only TCPdump should be used for capturing this traffic). Acronym: CCP. (CCP) mode automatically.

Important - In R80.40, the CCP always runs in the unicast mode.

You can configure the Cluster Control Protocol (CCP) Encryption on the Cluster Members.

See Viewing the Cluster Control Protocol (CCP) Settings.

Syntax for configuring the Cluster Control Protocol (CCP) Encryption

Shell	Command
Gaia Clish The name of the default command line shell in Check Point Gaia operating system. This is a restricted shell (role-based administration controls the number of commands available in the shell).	set cluster member ccpenc {off | on}
Expert mode	cphaconf ccp_encrypt {off | on} cphaconf ccp_encrypt_key <Key String>