mdsstat

Syntax

mdsstat [-h] [-m] [<Name or IP Address of Domain Management Server>]

Parameters

Parameter

Description

-h

Displays help message.

-m

Test status for Multi-Domain Server only.

<Name or IP address of Domain Management Server>

Specifies the Domain Management ServerClosed Check Point Single-Domain Security Management Server or a Multi-Domain Security Management Server. by its name or IPv4 address.

Possible Statuses of Processes

Status

Description

up

The process is up.

down

The process is downClosed State of a Cluster Member during a failure when one of the Critical Devices reports its state as "problem": In ClusterXL, applies to the state of the Security Gateway component; in 3rd-party / OPSEC cluster, applies to the state of the State Synchronization mechanism. A Cluster Member in this state does not process any traffic passing through cluster..

pnd

The process is pending initialization.

init

The process is initializing.

N/A

The process's PID is not yet available.

N/R

The process is not relevant for this Multi-Domain Server.

Example

[Expert@MDS:0]# mdsstat
+--------------------------------------------------------------------------------------+
|                              Processes status checking                               |
+-----+----------------+-----------------+------------+----------+----------+----------+
| Type| Name           | IP address      | FWM        | FWD      | CPD      | CPCA     |
+-----+----------------+-----------------+------------+----------+----------+----------+
| MDS |        -       | 192.168.3.101   | up 17284   | up 17266 | up 17251 | up 17753 |
+-----+----------------+-----------------+------------+----------+----------+----------+
| CMA |DOM211_Server   | 192.168.3.211   | up 32227   | up 32212 | up 25725 | up 32482 |
| CMA |DOM212_Server   | 192.168.3.212   | up 4248    | up 4184  | up 4094  | up 4441  |
+-----+----------------+-----------------+------------+----------+----------+----------+
| Total Domain Management Servers checked: 2     2 up   0 down                         |
| Tip: Run mdsstat -h for legend                                                       |
+--------------------------------------------------------------------------------------+
[Expert@MDS:0]#