ips bypass
Description
Controls the IPS
Check Point Software Blade on a Security Gateway that inspects and analyzes packets and data for numerous types of risks (Intrusion Prevention System). Bypass mode:
-
When CPU and/or Memory utilization reaches the configured higher threshold, IPS Software Blade
Specific security solution (module): (1) On a Security Gateway, each Software Blade inspects specific characteristics of the traffic (2) On a Management Server, each Software Blade enables different management capabilities. disables itself. -
When CPU and/or Memory utilization goes down
State of a Cluster Member during a failure when one of the Critical Devices reports its state as "problem": In ClusterXL, applies to the state of the Security Gateway component; in 3rd-party / OPSEC cluster, applies to the state of the State Synchronization mechanism. A Cluster Member in this state does not process any traffic passing through cluster. to the configured lower threshold, IPS Software Blade enables itself.
Syntax
|
|
Parameters
|
Parameter |
Description |
|||||
|---|---|---|---|---|---|---|
|
No Parameters |
Shows the applicable built-in usage. |
|||||
|
|
Disables the IPS Bypass mode. |
|||||
|
|
Enables the IPS Bypass mode. |
|||||
|
|
Configures the utilization thresholds (in per cent), at which to engage (higher threshold) or disengage (lower threshold) the IPS Bypass mode. The available options are:
Example:
|
|||||
|
|
Shows the status of the IPS Bypass Under Load:
|