'g_fwaccel dos' and 'g

Description

These commands control the Rate Limiting for DoS mitigation techniques in SecureXL.

Notes:

You must run these commands on a single Security Group member in the Expert mode:
- For IPv4: g_fwaccel dos ...
- For IPv6: g_fwaccel6 dos ...
On VSX Gateway, first go to the context of an applicable Virtual System.
In Expert mode, run: vsenv <VSID>

Syntax for IPv4

g_fwaccel [-i <SecureXL ID>] dos

blacklist <options>

config <options>

pbox <options>

rate <options>

stats <options>

whitelist <options>

Syntax for IPv6

g_fwaccel6 dos

blacklist <options>

config <options>

rate <options>

stats <options>

Parameters

Parameter	Description
`-i <`SecureXL ID`>`	Specifies the SecureXL instance ID (for IPv4 only).
`blacklist <`options`>`	Controls the IP blacklist in SecureXL.
`config <`options`>`	Controls the DoS mitigation configuration in SecureXL.
`pbox <`options`>`	Controls the Penalty Box whitelist in SecureXL.
`rate <`options`>`	Shows and installs the Rate Limiting policy in SecureXL.
`stats <`options`>`	Shows and clears the DoS real-time statistics in SecureXL.
`whitelist <`options`>`	Configures the whitelist for source IP addresses in the SecureXL Penalty Box.