Using Threat Extraction with VSX

To enable Threat Extraction on Virtual Systems:

1. If applicable, configure proxy settings for the VSX Gateway (VS0):
   1. In SmartConsole, from the Gateways & Servers view, double-click the VSX Gateway (VS0).
   2. From the navigation tree, select Network Management > Proxy.
   3. Configure the proxy settings, and click OK.
2. Enable Threat Extraction on the required Virtual Systems.

   Note - You do not enable it on the VSX Gateway (VS0).

3. Configure the Threat Prevention Policies for the relevant Virtual Systems.
4. Install the Threat Prevention Policies (and Access Control Policies if needed) on the relevant Virtual Systems.

For more about Threat Extraction, see the R80.30 Threat Prevention Administration Guide.

For more information about this Software Blade on VSX Gateway, see sk106496 and sk79700.