fw ctl conn

Description

Shows the list of Firewall Connection Modules.

This list shows various inspection Connection Modules, through which the traffic passes on this Security Gateway.

The available Connection Modules depend on the configuration and enabled Software Blades.

Important - In a cluster, these lists must be the same on all members of the cluster.

Syntax

fw [-d] ctl conn

Parameters

Parameter	Description
`-d`	Runs the command in debug mode. Use only if you troubleshoot the command itself.

Example

[Expert@MyGW:0]# fw ctl chain

Registered connections modules:

No. Name Newconn Packet End Reload Dup Type Dup Handler

Connectivity level 0:

1: Accounting 1: Accounting 0000000000000000 0000000000000000 FFFFFFFF8B8395A0 0000000000000000 Special FFFFFFFF8B831720

2: Authentication 2: Authentication FFFFFFFF8B3150A0 0000000000000000 0000000000000000 0000000000000000 Special FFFFFFFF8B34FCC0

8: NAT 8: NAT 0000000000000000 0000000000000000 FFFFFFFF8B6D1AF0 0000000000000000 Special FFFFFFFF8B6B8410

9: RTM 9: RTM 0000000000000000 0000000000000000 0000000000000000 0000000000000000 None

10: RTM2 10: RTM2 0000000000000000 0000000000000000 FFFFFFFF8B014970 0000000000000000 None

11: SPII 11: SPII FFFFFFFF8B412060 0000000000000000 FFFFFFFF8B41AF40 FFFFFFFF8B4016A0 None

13: VPN 13: VPN FFFFFFFF8A965440 0000000000000000 FFFFFFFF8AA4CC40 0000000000000000 Special FFFFFFFF8AA60490

Connectivity level 1:

13: VPN 13: VPN 0000000000000000 0000000000000000 0000000000000000 0000000000000000 None

[Expert@MyGW:0]#