cp_conf

Description

Configures or reconfigures a Check Point product installation. The available options for each Check Point computer depend on the configuration and installed products.

Syntax

cp_conf

-h

adv_routing <options>

auto <options>

corexl <options>

fullha <options>

ha <options>

intfs <options>

lic <options>

sic <options>

snmp <options>

Parameters

Parameter	Description
`-h`	Shows the built-in usage.
`adv_routing <`options`>`	Enables or disables the Advanced Routing feature on this Security Gateway. Note - Do not use these outdated commands. To configure Advanced Routing, see the R80.30 Gaia Advanced Routing Administration Guide.
`auto <`options`>`	Shows and configures the automatic start of Check Point products during boot on this Security Gateway.
`corexl <`options`>`	Enables or disables CoreXL on this Security Gateway.
`fullha <`options`>`	Manages Full High Availability Cluster.
`ha <`options`>`	Enables or disables cluster membership on this Security Gateway.
`intfs <`options`>`	Sets the topology of interfaces on a Security Gateway, which you manage with SmartProvisioning.
`lic <`options`>`	Manages Check Point licenses on this Security Gateway.
`sic <`options`>`	Manages SIC on this Security Gateway.
`snmp <`options`>`	Manages the Check Point SNMP Extension on this Security Gateway. Note - Do not use these outdated commands. To configure SNMP, see the R80.30 Gaia Administration Guide - Chapter System Management - Section SNMP.