In some configurations, the Default Filter prevents the Security Gateway from completing the reboot after installation.
First, look at the Default Filter. Does the Default Filter allow traffic required by the boot procedures?
If the boot process cannot finish successfully, remove the Default Filter:
Step |
Description |
---|---|
1 |
Connect to the Security Gateway over serial console. |
2 |
Reboot the Security Gateway. |
3 |
During boot, press any key to enter the Boot Menu. |
4 |
Select the Start in maintenance mode. |
5 |
Enter the Expert mode password. |
6 |
Set the Default Filter to not load again:
|
7 |
In the
|
8 |
Reboot the Security Gateway. |