Hardware Health Monitoring

You can monitor these hardware elements:

Fan sensors - Shows the fan number, status, and speed.
System Temperature sensors
Voltage sensors
Power Supplies (on servers that support it)

In addition, see sk119232 - Hardware sensors thresholds on Check Point appliances.

Showing Hardware Health Information - Gaia Portal

Note - The Hardware Health page appears only on supported hardware.

In the navigation tree, click Maintenance > Hardware Health.

You can see the status of the machine fans, system temperature, the voltages, and (for supported hardware only) the power supply.

For each component sensor, the table shows the value of its operation, and the status: OK, Low, or High.

To see the health history of a component, select the component sensor. A graph shows the values over time.
To change the time intervals that the graph shows, click the Minute arrows.
To view different times, click the Forward/Backward arrows.
To refresh, click Refresh.

Showing Hardware Health Information - Gaia Clish (show sysenv)

Description

These commands display the status for various system hardware components. Components, for which the status can be shown, include BIOS, cooling fans, , power supplies, temperature, and voltages.

The command returns information only for installed hardware components and only on supported hardware.

Syntax

show sysenv

all

bios

fans

temp

volt

Parameters

Parameter	Description
`all`	Shows all system/hardware information.
`bios`	Shows BIOS information.
`fans`	Shows speed of cooling fans.
`ps`	Shows voltages and states of power supplies.
`temp`	Shows information from temperature sensors.
`volt`	Shows voltages information.

Example

gaia> show sysenv all

Hardware Information

Name Value unit type status Maximum Minimum

+12V 29.44 Volt Voltage 0 12.6 11.4

+5V 6.02 Volt Voltage 0 5.3 4.75

VBat 3.23 Volt Voltage 0 3.47 2.7

gaia>

Showing Hardware Information

You can see information about the hardware, on which Gaia is installed using these commands:

Command	Description
`show asset`<SPACE><TAB>	You can run it in Gaia Clish only.
`cpstat os -f sensors`	You can run it in Gaia Clish, or Expert mode.

In addition, see sk119232 - Hardware sensors thresholds on Check Point appliances.

show asset

Description

Shows information about the hardware, on which Gaia is installed. You can run it in Gaia Clish only.

The information shown depends on the type of hardware. Common types of information shown are:

Serial number
Amount of physical RAM
CPU frequency
Number of disks in the system
Disk capacity

Syntax

show asset<SPACE><TAB>

show asset all

show asset <Category Name>

Parameters

Parameter	Description
<SPACE><TAB>	Shows a list of asset categories, such as `system` and `disk`. The available categories depend on the type of hardware.
`all`	Shows all available hardware information. The information shown depends on the type of hardware.
`<`Category Name`>`	Shows available information for a specified category.

Example 1

gaia> show asset<SPACE><TAB>

system all

gaia>

Example 2

gaia> show asset system

Platform: Check Point 5800

Serial Number: XXX

CPU Model: Intel(R) Xeon(R) E3-1285Lv4

CPU Frequency: 3400

Disk Size: 500GB

Number of Cores: 8

CPU Hyperthreading: Enabled

gaia>

cpstat os -f sensors

Description

Shows information from supported hardware sensors. You can run it in Gaia Clish, or Expert mode.

Syntax

cpstat os -f sensors

Example