'fwaccel synatk state' and 'fwaccel6 synatk state'

Print

Download PDF

Send Feedback

'fwaccel synatk state' and 'fwaccel6 synatk state'

Description

Controls the Accelerated SYN Defender states.

The states are independent for IPv4 and IPv6.

Important - This command is not intended for end-user usage. State transitions (between Ready, Grace and Active) occur automatically. This command provides a way to force temporarily a state transition on an interface or group of interfaces.

Syntax for IPv4

fwaccel synatk state

-h

-a

-d

-g

-i {all | external | internal | <Name of Interface>}

-m

-r

Syntax for IPv6

fwaccel6 synatk state

-h

-a

-d

-g

-i {all | external | internal | <Name of Interface>}

-m

-r

Parameters

Important - You can specify only one of these parameters: -a, -d, -g, -m, or -r.

Parameter	Description
`-h`	Shows the applicable built-in usage.
`-a`	Sets the state to Active.
`-d`	Sets the state to Disabled.
`-g`	Sets the state to Grace.
`-i all`	Applies the change to all interfaces (this is the default).
`-i external`	Applies the change only to external interfaces.
`-i internal`	Applies the change only to internal interfaces.
`-i <`Name of Interface`>`	Applies the change to the specified interface.
`-m`	Sets the state to Monitor (Detect only) mode.
`-r`	Sets the state to Ready.