fwm [-d] snmp_trap [-v <SNMP OID>] [-g <Generic Trap Number>] [-s <Specific Trap Number>] [-p <Source Port>] [-c <SNMP Community>] <Target> ["<Message>"]

-d

Runs the command in debug mode.

Use only if you troubleshoot the command itself.

For complete debug instructions, see the description of the fwm process in sk97638.

-v <SNMP OID>

Specifies an optional SNMP OID to bind with the message.

-g <Generic Trap Number>

Specifies the generic trap number.

One of these values:

• 0 - For coldStart trap
• 1 - For warmStart trap
• 2 - For linkDown trap
• 3 - For linkUp trap
• 4 - For authenticationFailure trap
• 5 - For egpNeighborLoss trap
• 6 - For enterpriseSpecific trap (this is the default value)

-s <Specific Trap Number>

Specifies the unique trap type.

Valid only of generic trap value is 6 (for enterpriseSpecific).

Default value is 0.

-p <Source Port>

Specifies the source port, from which to send the SNMP Trap packets.

-c <SNMP Community>

Specifies the SNMP community.

<Target>

Specifies the managed target host, to which to send the SNMP Trap packets.

Enter an IP address of a resolvable hostname.

"<Message>"

Specifies the SNMP Trap text message.

[Expert@MGMT:0]# fwm snmp_trap -g 2 -c public 192.168.3.52 "My Trap Message"

[Expert@MGMT:0]#

[Expert@MyGW_192.168.3.52:0]# tcpdump -s 1500 -vvvv -i eth0 udp and host 192.168.3.51

tcpdump: listening on eth0, link-type EN10MB (Ethernet), capture size 1500 bytes

22:49:43.891287 IP (tos 0x0, ttl 64, id 0, offset 0, flags [DF], proto: UDP (17), length: 103) 192.168.3.51.53450 > MyGW_192.168.3.52.snmptrap: [udp sum ok] { SNMPv1 { Trap(58) E:2620.1.1 192.168.3.240 linkDown 1486440 E:2620.1.1.11.0="My Trap Message" } }

CTRL+C

[Expert@MyGW_192.168.3.52:0]#