Enabling IPv6 on Gaia

IPv6 is automatically enabled if you configure IPv6 addresses in the Gaia First Time Configuration Wizard.

If you did not do this, manually enable the IPv6 support in Gaia.

In Gaia Portal:

1. With a web browser, connect to Gaia Portal at:

   https://<IP address of Gaia Management Interface>

2. From the navigation tree, click System Management > System Configuration.
3. In the IPv6 Support section, select On.
4. Click Apply.
5. When prompted, select Yes to reboot.

In Gaia Clish:

1. Connect to the command line on the Gaia computer.
2. Log in to Gaia Clish.
3. Enable the IPv6 support:

   set ipv6-state on

4. Save the changes:

   save config

5. Reboot:

   reboot

For more information:

See the R80.20 Gaia Administration Guide.