|
|
|
This command adds a new UTM-1 Edge SmartLSM Security Gateway. Applicable for UTM-1 Edge devices only.
Use this command to add a new UTM-1 Edge device to the SmartProvisioning system and assign it a specified SmartLSM Security Profile. Specify the product type of the UTM-1 Edge device and the firmware installed, which can be set as local, default or user-defined. It is also possible to assign an IP address range to Dynamic Objects, specifying whether to add them to the VPN domain.
To load new firmware on the UTM-1 Edge device, use SmartUpdate.
LSMcli [-d] <server> <user> <pswd> AddROBO VPN1Edge<RoboName> <Profile> <ProductType> [-RoboCluster=<OtherROBOName>] [-O=<RegistrationKey>] [[-CA=<CaName> [-R=<CertificateIdentifier#>][-KEY=<AuthorizationKey>]]] [-F=LOCAL|DEFAULT|<Firmware-name>] [-M=<MAC>] [-K=<ProductKey>] [-D[E]:<D.O. name>=<IP1>[-<IP2>] [-D[E]:...]]
AddROBO UTM-1 Edge Parameters
Parameter |
Description |
|---|---|
|
Name/IP address of the Security Management Server or Domain Management Server. |
|
User name of standard Check Point authentication method. |
|
Password of standard Check Point authentication method. |
|
Name of the UTM-1 Edge device. |
|
Name of a SmartLSM Security Profile that was defined in SmartConsole. |
|
Product type. |
|
Name of the already defined SmartLSM UTM-1 Edge device that participates in the SmartLSM Cluster with the newly created UTM-1 Edge device (if the |
|
Registration Key. |
|
Name of the Trusted CA object (created from SmartConsole). The IKE certificate request is sent to this CA. |
|
Key identifier of the specific certificate. |
|
Authorization Key that is sent to the CA for certificate retrieval. |
|
Firmware name, or LOCAL or DEFAULT. |
|
Mac address of the UTM-1 Edge, in the format xx:xx:xx:xx:xx:xx where "x" is a hexadecimal digit. |
|
Product key (license), in the format xxxxxx-xxxxxx-xxxxxx, where "x" is a hexadecimal digit. |
|
Name of the Dynamic Object. |
|
Obsolete, refer to the |
|
IP address range for the Dynamic Object. |
LSMcli mySrvr name pass AddROBO VPN1Edge MyRobo AnyProfile SBox-100
This example creates an object in SmartProvisioning for a UTM-1 Edge SmartLSM Security Gateway called MyRobo, based on a SmartLSM Security Profile defined in SmartConsole called AnyProfile. MyRobo is defined for a UTM-1 Edge on an SBox-100 device.
LSMcli mySrvr name pass AddROBO VPN1Edge MyRobo AnyProfile IP30 -O=AnyRegKey
-F=DEFAULT – M=00:08:AA:BB:CC:DD -K=123456-ABCDEF-ABC123
LSMcli mySrvr name pass AddROBO VPN1Edge MyRobo AnyProfile SBox-100
-F=Safe@_Safe@_3.0.23_Generic_Safe@_fcs
