Gateway Conversion Actions

These commands enable you to convert a gateway from a SmartLSM Security Gateway to a standard Security Gateway, and vice versa.

Convert ROBO VPN1

This command converts a SmartLSM Security Gateway to a Security Gateway. You can specify if the gateway is a CO gateway or not. Applicable to SmartLSM Security Gateways only.

Usage

LSMcli [-d] <server> <user> <pswd> Convert ROBO VPN1 <Name> [-CO] [-Force]

Parameters

Convert ROBO VPN1 Parameters

Parameter	Description
`server`	Name/IP address of the Security Management Server or Domain Management Server
`user`	User name of standard Check Point authentication method
`pswd`	Password of standard Check Point authentication method
`Name`	Name of the Security Gateway, or UTM-1 Edge device
`CO`	Define as a CO gateway
`Force`	Convert the gateway, even if no connection can be established Use with caution, as a forced conversion always succeeds, even if there is no connection to the gateway. If this happens, make sure the remote operations are done manually on the gateway computer: Execute the command `LSMenabler –r off` to turn off SmartLSM Security Gateway support. Execute the command `LSMenabler on` to make the gateway a CO gateway. In SmartConsole, define gateway parameters: interfaces, VPN communities, and so on. Then install the policy.

Example

LSMcli mySrvr name pass Convert ROBO VPN1 MyRobo –CO

LSMcli mySrvr name pass Convert ROBO VPN1 MyRobo -Force