fwm verify

Description

Verifies the specified policy package without installing it.

Note - On Multi-Domain Server, you must run this command in the context of the applicable Domain Management Server (mdsenv <IP Address or Name of Domain Management Server>).

Syntax

fwm [-d] verify <Policy Name>

Parameters

Item	Description
`-d`	Runs the command in debug mode. Use only if you troubleshoot the command itself. For complete debug instructions, see the description of the `fwm` process in sk97638.
`<`Policy Name`>`	Specifies the name of the policy package as configured in SmartConsole.

Item

Description

-d

Runs the command in debug mode.

Use only if you troubleshoot the command itself.

For complete debug instructions, see the description of the fwm process in sk97638.

<Policy Name>

Specifies the name of the policy package as configured in SmartConsole.

Example

[Expert@MGMT:0]# fwm verify Standard

Verifier messages:

Error: Rule 1 Hides rule 2 for Services & Applications: any .

[Expert@MGMT:0]#