cp_conf ha

Description

Enables or disables cluster membership on this Security Gateway.

Important - This command is for Check Point use only. To configure cluster membership, you must use the cpconfig command.

For more information, see the R80.20 ClusterXL Administration Guide.

Syntax

cp_conf ha {enable | disable} [norestart]

Parameter

Parameter	Description
`enable`	Enables cluster membership on this Security Gateway. This command is equivalent to the option Enable cluster membership for this gateway in the `cpconfig` menu.
`disable`	Disables cluster membership on this Security Gateway. This command is equivalent to the option Disable cluster membership for this gateway in the `cpconfig` menu.
`norestart`	Optional: Specifies to apply the configuration change without the restart of Check Point services. The new configuration takes effect only after reboot.

Description

enable

Enables cluster membership on this Security Gateway.

This command is equivalent to the option Enable cluster membership for this gateway in the cpconfig menu.

disable

Disables cluster membership on this Security Gateway.

This command is equivalent to the option Disable cluster membership for this gateway in the cpconfig menu.

norestart

Optional: Specifies to apply the configuration change without the restart of Check Point services. The new configuration takes effect only after reboot.

Example - Enable the cluster membership without restart of Check Point services

[Expert@MyGW:0]# cp_conf ha enable norestart

Cluster membership for this gateway was enabled successfully

Important: This change will take effect after reboot.

[Expert@MyGW:0]#

Example - Disable the cluster membership without restart of Check Point services

[Expert@MyGW:0]# cp_conf ha disable norestart

cpwd_admin:

Process CPHAMCSET process has been already terminated

Cluster membership for this gateway was disabled successfully

Important: This change will take effect after reboot.

[Expert@MyGW:0]#