cphastart

Description

Starts the cluster configuration on a Cluster Member after it was stopped with the cphastop command.

Note - This command does not initiate a Full Synchronization on the Cluster Member.

Syntax

cphastart

[-h]

[-d]

Parameters

Parameter	Description
`-h`	Shows the applicable built-in usage.
-`d`	Runs the command in debug mode. Notes: We recommend to redirect the output to a file: `cphastart -d > /var/log/cphastart_output.txt` Refer to the following lines in the output file: `prepare_command_args: -D ... start` `/opt/CPsuite-RXX/fw1/bin/cphaconf clear-secured` `/opt/CPsuite-RXX/fw1/bin/cphaconf -D ... start` Refer to the `$FWDIR/log/cphastart.elg` log file.

Parameter

Description

-h

Shows the applicable built-in usage.

-d

Runs the command in debug mode.

Notes:

We recommend to redirect the output to a file:
cphastart -d > /var/log/cphastart_output.txt
Refer to the following lines in the output file:
prepare_command_args: -D ... start

/opt/CPsuite-RXX/fw1/bin/cphaconf clear-secured

/opt/CPsuite-RXX/fw1/bin/cphaconf -D ... start
Refer to the $FWDIR/log/cphastart.elg log file.