License Installation

1. Quantum Maestro Orchestrators do not require a license.

2. Generate a Security Gateway license for the MAC Address of every Security Appliance you connect to a Quantum Maestro Orchestrator.

3. If the applicable license exists in the License Repository on the Check Point Management Server, it installs the licenses automatically.

   • If the Check Point Management Server is connected to the Internet, it pulls the licenses from the User Center.

   • If the Check Point Management Server is not connected to the Internet, then add the licenses manually in the SmartUpdate.

4. If it is necessary to install the license directly on a Security Appliance, these options are available:

   Installing the license on a specific Security Appliance from the Quantum Maestro Orchestrator

   Step	Instructions
   1	Connect to the command line on the Quantum Maestro Orchestrator. You connect through a dedicated port: In MHO-170 - the MGMT port on the front panel (top right corner). In MHO-140 - one of the ports on the rear panel.
   2	Log in to Expert mode.
   3	Connect to a specific Security Appliance with this command: member <Security Group ID> <Member ID> See Connecting to a Specific Security Group Member (member)
   4	Run the applicable "cplic put" command.

   Installing the license in the Gaia OS of the Security Group

   Step	Instructions
   1	Connect to the Gaia OS of the Security Group.
   2	Log in to Expert mode.
   3	Connect to a specific Security Appliance with this command: member <Security Group ID> <Member ID> See Connecting to a Specific Security Group Member (member)
   4	Run the applicable cplic put command.

   Installing the license a specific Security Appliance through the Console port

   Step	Instructions
   1	Connect to the Security Appliance through the Console port.
   2	Log in to the Gaia Clish, or Expert mode.
   3	Run the applicable cplic put command.