fw ctl multik stat

Description

Shows information for each CoreXL Firewall instance.

Important:

The same CoreXL command must run on all Security Group Members.

Therefore, you must run the CoreXL commands in either Gaia gClish, or Expert mode.

  • In Gaia gClish, run the "fw ctl ..." and "fw6 ctl ..." commands.

  • In the Expert mode, run the "g_fw ctl ..." and "g_fw6 ctl ..." commands.

Syntax for IPv4

fw [-d] ctl multik stat

Syntax for IPv6

fw6 [-d] ctl multik stat

Information in the output

  • The ID number of each CoreXL Firewall instance (numbers starts from zero).

  • The state of each CoreXL Firewall instance.

  • The ID number of CPU core, on which the CoreXL Firewall instance runs (numbers starts from the highest available CPU ID).

  • The number of concurrent connections the CoreXL Firewall instance currently handles.

  • The peak number of concurrent connections the CoreXL Firewall instance handled from the time it started.

Parameters

Parameter

Description

-d

Runs the command in debug mode.

Use only if you troubleshoot the command itself.

Best Practice - If you use this parameter, then redirect the output to a file, or use the script command to save the entire CLI session.

Example

[Expert@MyChassis-ch0x-0x:0]# g_fw ctl multik stat
ID | Active  | CPU    | Connections | Peak
----------------------------------------------
 0 | Yes     | 7      |           5 |       21
 1 | Yes     | 6      |           3 |       23
 2 | Yes     | 5      |           5 |       25
 3 | Yes     | 4      |           4 |       21
 4 | Yes     | 3      |           5 |       21
 5 | Yes     | 2      |           5 |       20
[Expert@MyChassis-ch0x-0x:0]#
 
[Expert@MyChassis-ch0x-0x:0]# g_fw6 ctl multik stat
ID | Active  | CPU    | Connections | Peak
----------------------------------------------
 0 | Yes     | 7      |           0 |        4
 1 | Yes     | 6      |           0 |        4
[Expert@MyChassis-ch0x-0x:0]#