cprinstall install

Description Installs Check Point products on remote Check Point Security Gateways.

To install a product package you must specify a number of options. Use the cppkg print command and copy the required options.

Syntax:

> cprinstall install [-boot] <Object name> <vendor> <product> <version> [sp]

Parameter	Description
`-boot`	Boots the remote computer after installing the package. Note - Only boot after ALL products have the same version. Boot will be canceled in certain scenarios.
`Object name`	Object name of the Check Point Security Gateway defined in SmartConsole.
`vendor`	Package vendor. For example, `checkpoint`
`product`	Package name.
`version`	Package version.
`sp`	Package minor version.

Note - Before transferring any files, this command runs the cprinstall verify command to verify that the operating system is appropriate and that the product is compatible with previously installed products.

Example:

# cprinstall install -boot fred checkpoint firewall R70

Installing firewall R75.20 on fred...

Info : Testing Check Point Gateway

Info : Test completed successfully.

Info : Transferring Package to Check Point Gateway

Info : Extracting package on Check Point Gateway

Info : Installing package on Check Point Gateway

Info : Product was successfully applied.

Info : Rebooting the Check Point Gateway

Info : Checking boot status

Info : Reboot completed successfully.

Info : Checking Check Point Gateway

Info : Operation completed successfully.