Installing a Multi-Domain Server on Open Servers

To install and configure Check Point products on Gaia, use the First Time Configuration Wizard or configure the operating system and install the products in the Gaia Portal.

For hardware requirements, see the R80.10 Release Notes.

To install Multi-Domain Server on an Open Server:

1. In your web browser, connect to the Gaia Portal:

   https://<Gaia management IP address>

2. In the Gaia Portal window, log in with the administrator name and password that you defined during Gaia installation.
3. The First Time Configuration Wizard opens.
4. Click Next.
5. Select Continue with R80.10 configuration.
6. Click Next.
7. Set an IPv4 address for the management interface.

   If you change the management IP address, the new IP address is assigned to the interface. The old IP address is added as an alias and is used to maintain connectivity.

   Click Next.

8. Enter the Host Name of the server.

   Optional:

   • Enter the Domain Name, and IPv4 addresses for the DNS servers.
   • Set the IP Address and Port for a Proxy Server.

   Click Next.

9. Set the date and time manually, or enter the hostname and IPv4 address of the NTP server. Click Next.
10. Enter the username and password for the Multi-Domain Server administrator account. Click Next.
11. For Installation Type, select Multi-Domain Server. Click Next.
12. For the type of server, select Primary Multi-Domain Server.
13. Select the Leading VIP Interfaces.

    Leading interfaces are physical interfaces that connect to the external network. These interfaces are for Domain Management Server virtual IP addresses. Each leading VIP interface can have up to 250 virtual IP addresses (250 Domain Management Servers).

14. Configure the GUI clients that can log into the Multi-Domain Server. Click Next.
15. Set the Name and Password for the Multi-Domain Server administrator account. Click Next.
16. Review the summary and then click Finish.
17. Click Yes when prompted to start the configuration process.

    A progress bar tracks the configuration of each task.

18. Click OK.
19. If the Help Check Point Improve window opens, click Yes or No. Check Point recommends that you click Yes. Your data is never shared with third parties.