Understanding Full High Availability Cluster on Appliances

In a Full High Availability Cluster on two Check Point Appliances, each appliance runs both as a ClusterXL Cluster Member and as a Security Management Server, in High Availability mode.

Important - You can deploy and configure a Full High Availability Cluster only on Check Point Appliances that support Standalone configuration. See the R80.10 Release Notes.

This deployment lets you reduce the maintenance required for your systems.

In the image below, the appliances are denoted as (1) and (3).

The two appliances are connected with a direct synchronization connection (2) and work in High Availability mode:

• The Security Management Server on one appliance (for example, 1) runs as Primary, and the Security Management Server on the other appliance (3) runs as Secondary.
• The ClusterXL on one appliance (for example, 1) runs as Active, and the ClusterXL on the other appliance (3), runs as Standby.
• The ClusterXL Cluster Members synchronize the information about the traffic over the synchronization connection (2).

For information on ClusterXL functionality, see the R80.10 ClusterXL Administration Guide.

For information on Security Management Servers, see the R80.10 Security Management Administration Guide.

Important - SmartEvent Server is not supported in Management High Availability and Full High Availability Cluster environments (sk25164). For these environments, install SmartEvent Server and SmartReporter on dedicated machines.