CLI Reference (interface)

This section summarizes the Gaia Clish interface command and its parameters.

Description

Add, delete and configure interface properties.

Syntax

• To add an interface:

  add interface <Name of Interface> 6in4 "<Tunnel ID>" remote <IPv4 Address> [ttl <Time>] <Name of Interface> alias <IPv4 Address>/<Mask Length> <Name of Interface> vlan <VLAN ID> lo loopback <IP Address>/<Mask>

• To configure an interface:

  set interface <Name of Physical Interface> auto-negotiation {on | off} comments "<Text>" ipv4-address <IPv4 Address> mask-length <Mask Length> subnet-mask <Mask> ipv6-address <IPv6 Address> mask-length <Mask Length> ipv6-autoconfig {on | off} link-speed <Speed_Duplex> mac-addr <MAC Address> monitor-mode {on | off} mtu <68-16000 | 1280-16000> rx-ringsize <0-4096> state {on | off} tx-ringsize <0-4096>

• To see the configuration of an interface:

  show interface <Name of Interface>

  show interfaces all

• To delete an interface:

  delete interface <Name of Interface> 6in4 "<Tunnel ID>" 6to4 "<Tunnel ID>" alias <Name of Alias Interface> ipv4-address <IPv4 Address> ipv6-address <IPv6 Address> ipv6-autoconfig loopback <IP Address> vlan <VLAN ID>

Important - After you add, configure, or delete features, run the save config command to save the settings permanently.

Parameters

See the specific sections:

• Configuring Physical Interfaces - Gaia Clish
• Configuring Aliases - Gaia Clish
• Configuring VLAN Interfaces - Gaia Clish
• Configuring Bond Interfaces - Gaia Clish
• Configuring Bridge Interfaces - Gaia Clish
• Configuring Loopback Interfaces - Gaia Clish
• Configuring VPN Tunnel Interfaces - Gaia Clish

Comment

There are some command options and parameters, which you cannot configure in the Gaia Portal.