Upgrade Using Boot Loader

To upgrade the Check Point Appliance using U-boot (boot loader):

Note - In 770/790 and 910 appliances, Bootloader is supported only through the DMZ port and is not available through the LAN ports.

1. Connect to the appliance with a console connection (use the serial console connection on the back panel of the appliance), boot the appliance and press Ctrl+C. The Gaia Embedded Boot Menu is shown.
2. Press 5 to select Install/Update Image/Boot-Loader from Network.
3. You are asked if you want to manually load the image from a TFTP server, or if you want to use automatic mode with a bootp server.
4. If you select manual mode, you are asked to fill in the IP of the Check Point Appliance, the IP of the TFTP server, and the image name.
5. If you select automatic mode, the procedure starts automatically to search for the bootp server.
6. While in menu mode, press Ctrl+C again to return to the Boot Loader menu.

   During the upgrade, all LAN Link and Activity LEDs blink orange and green alternately to indicate progress. This takes up to a minute.

   700 and 910 Appliances - When all LAN Link and Activity is successfully completed, the LEDs light in green, and the appliance waits for you to press a key. Error in the upgrade process is indicated by all LAN Link and Activity LEDs blinking red.