Inserting Chassis Management Modules

To insert a Chassis Management Module:

1. On the CMM, remove the tape on the battery.

   This tape protects the battery life before installation.

2. Open the upper latch.
3. Insert the Chassis Management Module into the allocated slot.

   Note - If you have only one CMM, we recommend inserting it into the left slot.

4. Close the latch.
5. Tighten the two thumb screws.
6. After power up, all LEDs must light up for 1-2 seconds. The ACT and PWR LEDs continue to show green after the other LEDs turn off.