Open Frames Download Complete PDF Send Feedback Print This Page

Previous

Next

Multicast restrictions

Multicast access restrictions can be defined on each interface. These restrictions specify multicast groups (that is, addresses or address ranges) to allow or block.

Configuration

  1. Open SmartDashboard and edit the Multicast Restrictions tab:
  2. Go to Gateway Properties > Topology > Add or Edit interface > Multicast Restrictions tab

Parameter

Description

 
Drop multicast packets whose
destination is in the list

Specifies that outgoing packets from this interface to the listed multicast destinations will be dropped.

 
Drop all multicast packets 
except those whose destination
is in the list

Specifies that outgoing packets from this interface to all multicast destinations except those listed will be dropped.

Add

Add a Multicast address or address range to the list.

Remove

Remove a selected Multicast address or address range from the list

Tracking

Allows you to choose whether and how to track when multicast packets are dropped.

Limitations:

Multicast restriction is not supported on bridge interfaces.

 
Top of Page ©2014 Check Point Software Technologies Ltd. All rights reserved. Download Complete PDF Send Feedback Print