Open Frames Download Complete PDF Send Feedback Print This Page

Previous

Next

Setting a Bonding Mode

Description

Use this command to set a bonding mode.

The following Bond modes are supported in the 61000/41000 Security System:

8023AD (LACP): Do dynamic bonding according to the IEEE 802.3ad protocol

Active/Backup: Bond build up from one interface Active while other interface is in standby. When the active interface encounters a problem failover occurs to other Bond interface.

XOR: Do load sharing based on layer2, or 3 and 4.

Note: round-robin mode is not supported on the 61000/41000 Security System.

Syntax

set bonding group <bond_id> mode <bond_MODE>

Example

set bonding group 4 mode 8023A

Output

1_01:
success
1_02:
success
1_03:
success
2_01:
success
2_03:
success
>

Explanation

Physical interfaces enslaved to bond4 do load sharing according to the 802.3ad protocol

 
Top of Page ©2014 Check Point Software Technologies Ltd. All rights reserved. Download Complete PDF Send Feedback Print