Open Frames Download Complete PDF Send Feedback Print This Page

Previous

Next

Showing Distribution Status

Use this command to show a summary or detailed status report of the Distribution mode.

Syntax

show distribution status [verbose]

Parameter

Description

verbose

Shows a detailed report for all SGMs and SSMs

Example

> show distribution status verbose
Topic:                                    Configuration:                  
distribution mode                         user-network                    
policy mode                               on                              
ssm 1 mode                                user                            
ssm 2 mode                                network                         
ipv6 mode                                 off                             
spi mode                                  off                             
40g mode                                  off                             
matrix size                               2048                            
interface eth1-01 mode                    policy-internal                 
interface eth2-01 mode                    policy-external

Explanation of the output data

  • distribution mode - Currently configured Distribution mode.
  • policy mode - Auto-Topology assignment (On = Auto-topology. Off= Manual-General).
  • ssm mode - Distribution Mode assignment for each SSM.
  • ipv6 mode - Shows if IPv6 is enabled for this system (on/off).
  • spi mode - Shows if SPI affinity is enabled for this system (on/off).
  • 40g mode - Shows if QSFP ports are working at 40GbE (On) or at 4 x 10GbE (Off).
  • matrix size - The size of the Distribution matrix. The Distribution matrix is a table containing SGM IDs that are used for traffic assignment.
  • interface - Shows the Distribution mode assignment for each interface.
 
Top of Page ©2014 Check Point Software Technologies Ltd. All rights reserved. Download Complete PDF Send Feedback Print