|
|
|
This example shows the summary output for all diagnostic tests. When a test fails, the reasons for failure show in the Reason column.
> asg diag verify
Duration of tests vary and may take a few minutes to complete
--------------------------------------------------------------------------------
| Tests Status |
--------------------------------------------------------------------------------
| ID | Title | Result | Reason |
--------------------------------------------------------------------------------
| System Components |
--------------------------------------------------------------------------------
| 1 | System Health | Failed (!) | (1)Chassis 1 error |
| | | | (2)Chassis 2 error |
| 2 | Hardware | Failed (!) | (1)Chassis fan is missing |
| | | | (2)CMM is missing |
| | | | (3)CMM active/standby configuration |
| | | | (4)SSM is missing |
| 3 | Resources | Passed | (1)Memory capacity mismatch |
| 4 | Software Versions | Failed (!) | |
| 5 | Software Provision | Passed | |
| 6 | CPU Type | Passed | |
| 7 | Media Details | Passed | |
| 8 | Chassis ID | Passed | |
--------------------------------------------------------------------------------
| Policy and Configuration |
--------------------------------------------------------------------------------
| 9 | Distribution Mode | Passed | |
--------------------------------------------------------------------------------
| VSX Configuration |
--------------------------------------------------------------------------------
| 10 | USER KERNEL Dist | Passed | |
--------------------------------------------------------------------------------
| Policy and Configuration |
--------------------------------------------------------------------------------
| 11 | DXL Balance | Passed | |
| 12 | Policy | Passed | |
| 13 | AMW Policy | Passed | (1)Not configured |
| 14 | SWB Updates | Passed | (1)Not configured |
--------------------------------------------------------------------------------
| VSX Configuration |
--------------------------------------------------------------------------------
| 15 | VSX Configuration | Passed | |
| 16 | HW Utilization | Failed (!) | (1)Connection capacity is too low |
| 17 | BMAC VMAC verify | Passed | |
--------------------------------------------------------------------------------
| Policy and Configuration |
--------------------------------------------------------------------------------
| 18 | Installation | Passed | |
| 19 | Security Group | Passed | |
| 20 | Cores Distribution | Passed | |
| 21 | SPI Affinity | Passed | (1)Not configured |
| 22 | Clock | Passed | |
| 23 | Licenses | Passed | (1)Trial license installed |
| 24 | Hide NAT range | Passed | (1)Not configured |
| 25 | LTE | Passed | (1)Not configured |
| 26 | IPS Enhancement | Passed | (1)Not configured |
| 27 | Configuration File | Passed | |
--------------------------------------------------------------------------------
| Networking |
--------------------------------------------------------------------------------
| 28 | MAC Setting | Passed | |
| 29 | ARP Consistency | Passed | |
| 30 | Interfaces | Failed (!) | (1)RX drop |
| | | | (2)Interface down |
| 31 | Bond | Failed (!) | |
| 32 | Bridge | Passed | (1)Not configured |
| 33 | IPv4 Route | Passed | |
| 34 | IPv6 Route | Passed | (1)Not configured |
| 35 | OS Route Cache | Passed | |
| 36 | Dynamic Routing | Passed | |
| 37 | Local ARP | Passed | (1)Not configured |
| 38 | Port Speed | Failed (!) | (1)Inconsistency between chassis and |
| | | | conf file |
| 39 | SSM QoS | Passed | |
| 40 | IGMP Consistency | Passed | (1)Not configured |
| 41 | PIM Neighbors | Passed | (1)Not configured |
| 42 | ACL Filter | Passed | |
--------------------------------------------------------------------------------
| DoS |
--------------------------------------------------------------------------------
| 43 | SYN Defender | Passed | |
| 44 | F2F Quota | Passed | |
--------------------------------------------------------------------------------
| Misc |
--------------------------------------------------------------------------------
| 45 | Core Dumps | Failed (!) | |
| 46 | Syslog | Passed | (1)Log server is not configured |
| 47 | Processes | Passed | |
| 48 | Performance hogs | Failed (!) | |
--------------------------------------------------------------------------------
| Tests Summary |
--------------------------------------------------------------------------------
| Passed: 39/48 tests |
| Run: "asg diag list 1,2,4,7,16,30,31,38,45,48" to view a complete list of fail |
| ed tests |
| Output file: /var/log/verifier_sum.1-48.2015-12-30_17-07-38.txt |
--------------------------------------------------------------------------------
