Using Debug Mode

Use the debug parameter to show more data about the memory that the VSX Gateway uses. You cannot use the -vs, unit and sort parameters in debug mode. The memory is shown in kilobytes.

Syntax

# vsxmstat debug

Output

VSX Memory Status

=================

Memory Total: 1021152.00 KB

Memory Free: 324788.00 KB

Swap Total: 2096472.00 KB

Swap Free: 2096404.00 KB

Swap-in rate: 375.34 KB

 VSID |      Private_Clean |      Private_Dirty |    DispatcherGConn
======+====================+====================+====================+

    0 |        13544.00 KB |       144268.00 KB |            0.00 KB |

    1 |         1740.00 KB |        46276.00 KB |            0.00 KB |

    2 |         1720.00 KB |        46868.00 KB |            0.00 KB |

    3 |         1720.00 KB |        46644.00 KB |            0.00 KB |

    4 |         1712.00 KB |        45144.00 KB |            0.00 KB |

    5 |         1712.00 KB |        45836.00 KB |            0.00 KB |

    6 |         1720.00 KB |        45000.00 KB |            0.00 KB |

    7 |         1720.00 KB |        45044.00 KB |            0.00 KB |

Comments

By default the debug parameter shows these memory fields: