Open Frames Download Complete PDF Send Feedback Print This Page

Previous

Next

Rebooting SGMs During Memory Leak Detection

You must do this procedure before you reboot an SGM that does not run Memory Leak Detection when a different SGM runs Memory Leak Detection. If you do not, the SGM you reboot starts Memory Leak Detection after it reboots.

To prepare an SGM to reboot:

Run these commands on the SGM in clish:

> g_update_conf_file fwkern.conf fw_salloc_debug_leaks=
> g_update_conf_file fwkern.conf fw_hmem_debug_leaks=
> g_update_conf_file fwkern.conf fw_kmem_cphwd_use_fw=
> g_update_conf_file fwkern.conf fw_kmem_detailed_leak_report=
 
Top of Page ©2014 Check Point Software Technologies Ltd. All rights reserved. Download Complete PDF Send Feedback Print