Chassis Management Module (CMM) CLI

The Chassis Management Module (CMM) monitors and controls hardware modules in the Chassis. The CCM communicates with a dedicated SGM using SNMP. If a hardware sensor reports a problem, the CMM automatically takes action or sends a report. CMMs also have a Command Line Interface.

To connect to the active CMM:

1. Connect to the serial port on the front panel of the CMM.
2. In your terminal emulation program, set the baud rate to 9600.
3. Enter admin for the user name and password.
4. Open a telnet or SSH session from one of the SGMs.
5. Ping these addresses:
   • 198.51.100.33
   • 198.51.100.233
6. Telnet or SSH from the SGM to the active CMM.
7. Enter admin for the user name and password.

To connect to the standby CMM:

1. Connect to the active CMM.
2. At the command prompt, run: ifconfig
3. Record the IP Address for the USB interface.
4. Telnet or SSH from the active CMM to the standby CMM with the IP from the table below.