Configuring SGMs (asg_blade_config)
Use asg_blade_config to manage SGMs:
- Copy the SGM configuration from a different SGM
- Change the synchronization start IP address
- Reset the system uptime value
- Get a policy from the Security Management server
Syntax
# asg_blade_config pull_config [policy|all] [-force] <ip>
# asg_blade_config full_sync <ip>
# asg_blade_config set_sync_start_ip <ip>
# asg_blade_config reset_uptime
# asg_blade_config reset_uptime_user
# asg_blade_config get_smo_ip
# asg_blade_config is_in_security_group
# asg_blade_config is_in_pull_conf_group|config fetch_smc
# asg_blade_config upgrade_start <new_version> [cu]
# asg_blade_config upgrade_stop|upgrade_stat|upgrade_cu
Parameter
|
Description
|
pull_config
|
Copy the configuration from another SGM.
|
full_sync <ip>
|
Run a full synchronization from another SGM.
<ip> - Synchronization interface on remote SGM
|
set_sync_start_ip <ip>
|
Changes the Synchronization start IP address from the local SGM to the specified IP address.
|
reset_uptime
|
Resets the system uptime value on all SGMs to the current time.
|
reset_uptime_user
|
An interactive command that resets the uptime for all SGMs to a user configured time.
|
get_smo_ip
|
Return the Synchronization IP address of the Single Management Object, as defined in SmartDashboard. This address is not shown in SmartDashboard.
|
is_in_security_group
|
Make sure that the local SGM is in the Security Group.
|
is_in_pull_conf_group
|
Make sure that the local SGM is in the Pulling Configuration Group. If not, the SGM cannot copy the configuration and policy.
|
config fetch_smc
|
Get the policy from the Security Management Server, and send it to all SGMs.
|
upgrade_start <new_version> [cu]
|
Start the upgrade procedure.
<new_version> - New version name.
[cu] - Specifies the Connectivity upgrade.
|
upgrade_stop
|
Stop the upgrade procedure.
|
upgrade_stat
|
Shows the upgrade procedure and policy status.
|
upgrade_cu
|
Change from Zero Downtime upgrade to Connectivity upgrade.
|
Troubleshooting asg_blade_config
To troubleshoot problems associated with the asg_blade_config command, examine the logs stored at: /var/log/blade_config
For example, if the SGM unexpectedly reboots, you can search the log file for the word reboot to learn why.
|
